-
Dec 23, 2022Analysis of Process Conditions of POM Injection MoldDrying: If the material is stored in a dry environment, drying is usually not required. -
Dec 22, 2022Main differences between POM board and HDPE boardPOM (Polyoxymethylene) plate, commonly known as Sai steel plate, is made by extruding POM plastic particles through an extruder at high temperature and then extruding them through -
Dec 22, 2022Application of POM Rod in Bearing IndustryPOM rod has excellent low friction and wear resistance, and has the same rigidity and strength as metal. -
Dec 21, 2022What is the processing accuracy of peekGenerally, injection molding can reach about 0.1. It is possible to control it to about 0.015 according to different wall thicknesses and product structures. -
Dec 20, 2022How about the screw performance of PEEK?PEEK screws can be molded by injection process in one time, with low processing cost and price advantage; More corrosion resistant than metal screws; Never rust; Light weight; High -
Dec 19, 2022How to control burr of peek machined partsThe tool with fine steel stone coating is used, with sharp edge, and the cutter is better for reverse milling. -
Dec 18, 2022What is the difference between PVDF and PEEK?PEEK (polyether ether ketone) material has extremely high continuous service temperature (about 260 ℃), high stiffness and hardness, and unique high tensile strength and fatigue st -
Dec 17, 2022Attention shall be paid to peek injection moldingPEEK's injection mold is similar to ordinary mold in structural design, but the following situations need to be considered: the mold material needs to be able to maintain sufficien
