Jun 26, 2024 Leave a message

How to control and reduce deformation during PEEK plate and rod processing

How to control and reduce deformation during PEEK plate and rod processing

 

PEEK (polyetheretherketone) material may be deformed due to the problem of internal stress during processing. This deformation can be controlled and reduced by the following methods:

 

1.Control the amount of material removal: By accurately controlling the allowance of the blank, the stress deformation caused by processing can be reduced. Symmetrical machining also helps to counteract the stresses generated during machining.

 

2.Annealing treatment: If the stress inside the material is not completely removed, the internal stress can be further reduced by annealing treatment.

 

3.Change the clamping method: The deformation generated during the clamping process can be reduced by changing the form of clamping. For example, larger contact surfaces or vacuum cups can be used to hold the material in place.

 

4.Optimize cooling conditions: In the machining process, especially for parts with not very large wall thickness, the use of coolant and adjusting the feed speed can reduce the deformation.

 

5.Adjust the process parameters: including temperature, pressure and time, etc., to ensure the stability of the molding quality.

 

6. Choose the right tool and processing method: For the cutting of PEEK material, it is recommended to use carbide tool edge or PCD tool D. At the same time, attention should be paid to the thermal expansion and internal stress in the processing process, and the deformation of PEEK material in the processing process can be effectively controlled and reduced through the comprehensive application of the above methods.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry